Drawing Settings (Tools menu)

Use this command to pop up the Drawing Settings dialog.

This Dialog is Used to do settings for layouts seen in Result page. Different types of hatching patterns can be used to represent different sections such as Kerf  wastage , offcut and trim waste in the layout which can be set using this dialog from the Tools menu or toolbar. You can also use colors to mark off same slits. This increases the visual effect and understanding of the layout.

Trim Optimization Software : Drawing Setting - PLUS Slitting

Slit Name

Shows the name of each slit in the layout.
Compact Names If same slits with more no. comes in a layout one after another then this option points name and size of that slits on 1st slit itself.
Slit Size This shows the size of the slit
Knife Position It gives the knife position of the slit.
Use color If you don't want the slits to be in colors, in  layout drawing, then by using option you can change it. Just uncheck this option. Normally this is done while taking RTF Report for Printing. See layout below.

Trim Optimization : Layout drawing with no slit color- PLUS Slitting

Layout Drawing.