The Coil page contains a table with the following columns, where you can specify information about the material available for optimization.
| Coil | Enter a unique name for each Coil. |
| Width | Width of the Coil. You can select the units using the Units dialog. |
| Qty | Available quantity of Coil. Has to be zero or greater. |
| Material | Specify the material or section type of each stock. Parts of the same material are matched and nested together on appropriate stock. |
| Length/Coil | Length of single coil. |
| Cost/Length | Cost per unit length (Length Unit Is Same as Units set in Units dialog.) |
| Left Trim | Width of Trim on left side of Coil. |
| Right Trim | Width of Trim on Right side of Coil. |
| Remarks | Additional information about the Coil. |