Large Parts Page (Optional Feature)

The large part page contains a table where you can input the information of the parts that needs to split. Parts that do not fit in any stock or those that cannot be split are highlighted in Red. You can adjust the width of the columns as required.

Part	Enter a unique part name for each part.
Length	Length of the part. You can select the units using the Units dialog.
Qty	Required quantity of part. Has to be zero or greater.
Section Type	This column will appears, if you have purchased  'Sections' module along with PLUS 1D. It provides the type of sections
Section	Specify the material or section type of each stock. Parts of the same material are matched and nested together on appropriate stock. See options dialog.
Cut Allowance	Specify the additional distance to be cut for a part, if it has angular cuts on the sides.
Powder Coat	Specify the required powder coating type for the part.
Remarks	Additional information about the part.
Maximum qty to split	Specify the maximum quantity that has to be split. The remaining qty will be nested without splitting, if possible.
Auto Split	Specify whether you want the part to be split automatically or manually. By default Auto Split is enabled.
Edit Split	You can add or edit the splits manually, if desired, in the dialog that pops-up on clicking the button.
Cut	The number of parts nested is displayed here, once the optimization is done. The incompletely nested parts are shown in red.
	This button will split all the parts that are selected for auto split.

Split Information Grid

This grid displays the split pieces for the current selected part (row).

See Also

• Concept Of Joints

• Joint Rules

• Editing The Joints